Loading ...
Loading ...
Loading ...
13
ENGLISH
• Do not start the miter saw without checking for
interference between the blade and table insert. Damage
could result to the blade, table insert or turntable if blade
strike occurs during the cutting operation.
1. To remove, loosen and remove the four screws
33
on the table insert
9
with a Phillips screwdriver and
remove the table inserts.
2. To install, reposition the table insert, install the four
screws and tighten.
Bevel Stop Adjustment
WARNING: To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
90° (0°) Bevel Adjustment (Fig. Q, R)
1. Loosen bevel lock knob
12
and tilt the cutting arm
completely to the right. Tighten the bevel lock knob.
2. Place a combination square
34
on the miter table
35
with the ruler against the table and heel of the square
against the saw blade.
3. If the blade is not 90° square with the miter table, turn
the set screw
36
in or out with a 2.5 mm hex wrench
until the blade is square with the miter table.
4. Tighten the bevel lock knob
12
after alignment is
achieved.
Fig.P
9
33
Fig.Q
36
12
90° Bevel Pointer Adjustment (Fig. S)
WARNING: To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
1. When the blade is exactly 90° (0°) to the table, loosen
the bevel pointer screw
37
using a Phillips screwdriver.
2. Adjust bevel pointer
38
to the “0” mark on the bevel
scale and retighten the screw
37
.
45° Bevel Stop Adjustment (Fig. T)
1. Set the miter angle to zero degree.
2. Loosen the bevel lock knob
12
and tilt the cutting arm
completely to the left.
3. Using a combination square, check to see if the blade is
45° to the table.
4. If the blade is not at 45° to the miter table, tilt the
cutting arm to zero degree, loosen the lock nut
39
and turn the bolt
40
in or out accordingly with an
adjustable wrench.
5. Tilt the cutting arm back to the left and recheck
alignment.
6. Repeat above steps until the blade is 45° to the table.
Once alignment is achieved, tighten the lock nut
39
to
secure the bolt
40
.
Fig.R
34
35
Fig.S
38
37
Fig.T
12
39
40
Loading ...
Loading ...
Loading ...