Loading ...
Loading ...
Loading ...
SunBriteTV Signature 2 Series 4K Ultra HD Operator’s Manual
Page 9
TV Installation – Rear Panel Connections
Connections
1. 2.5mm power jack - 12v @ 3amps Auxillary power supply
2. 5 pin din jack - SunBriteTV optional speaker bar connection output.
3. Direct IR input 3.5mm Jack
4. IR WINDOW - Rear IR receiver, allows IR emitter to be installed inside the cable compartment.
5. RS232 - 3.5mm Stereo Jack - For remote control using RS232 commands.
6. Ethernet- Network Connection - IP Control.
7. USB power port - 5vdc @ 3.5a Auxillary power supply (Power only - no data)
8. 1.3mm Power Jack - 5vdc @ 3.5a Auxillary power supply
9. HDMI 1 & 2 - Connects to devices that use HDMI cables such as Blu-ray or HD DVD player or HD cable / satellite set-top box. This connection
port receives pure digital audio and high denition signal through one single cable. This port also can accept a HDCP video device for video
or PC for monitor display usage. Use the SOURCE button to select HDMI1 on your MAIN SOURCE to view this connection. Please note: when
using HDMI, your sound signal must be PCM for the TV to decode digital audio. When using this source for PC display, you may have to
connect the audio cable to VGA Stereo Input for audio.
10. VGA - This connection port connects to a PC for video using VGA cable. Be sure to connect your audio cable to the VGA Stereo input if you
require sound out of the VGA video source. Use the SOURCE button to select PC on your MAIN SOURCE to view this connection
11. VGA STEREO INPUT - This connection 3.5mm jack provides audio to the TV when using a PC or a DVI video device. Use a 3.5mm mini-jack
audio cable (headphone jack) to provide audio for a HDCP enabled DVI video device or PCs with VGA or DVI connection.
12. AV (CVBS) - Connects to devices that use legacy composite cables such as older VCR or camcorder or video game consoles. Connect the
video portion with either the yellow connector. Use the SOURCE button to select AV on your MAIN SOURCE to view this connection.
13. COMPONENT - Requires use to 3.5mm to RCA cable. (not included) The RCA jacks are for DVD players or satellite/cable set-top boxes that
use component cables. From left to right, connect green, blue and red for video, and then connect white for left channel audio, red for right
channel audio. Use the Source Button to select Component to view this connection.
14. ANALOG AUDIO OUT (Variable) - Used to connect headphones, stereo receivers and amplied speakers via a 3.5mm headphone jack.
15. DIGITAL AUDIO OUT - This connection port is used for sending out audio signals to other audio devices such as stereo/surround sound
receivers. The optical TosLink connector sends out either bit-stream or PCM digital sound signal to a home theater receiver with digital input
16. ATSC/NTSC/QAM Coax input – This connection is for digital or analog cable without the cable box or over-the-airwave antennas. The tuner
is a hybrid tuner that tunes to both analog and digital channels. This connection uses coaxial RF cable. For over- the airwave digital stations
please check http://www.antennaweb.org.
17. USB SERVICE PORT - Can be used for photo and MP3 media playback or rmware updates using a USB ash drive.
6
7
11
12
13
See next
page
1
10
9
16
5
2
4
3
8
14
15
17
Warning: Connect a network connection with an active connection to a ethernet switch.
Loading ...
Loading ...
Loading ...