Loading ...
Loading ...
Loading ...
31
7. Close the Print Head on both sides and
make sure it locks into place.
8. Set the media sensor type and calibrate
the selected sensor.
9. Perform the calibration using the BPM.
For more information about sensor
calibration, see section
8.2 Auto-Calibrating the Media Sensor
using the BPM.
Note
1. Calibrate the Gap/Black Mark
Sensor before loading media in
Peeler Mode to avoid paper jams.
2. Make sure you thread the label over
the Media Guide Bar and under the
Damper as shown.
10. Turn the Print Head Release Lever, Label
Guide Release Lever and Peel-Off Kit,
and pull approximately 650 mm of the
label roll through the Media Output Slot.
11. Remove some labels leaving only the
liner.
Label
Liner
Loading ...
Loading ...
Loading ...