Loading ...
Loading ...
Loading ...
(404,1)
北米Model "A1390BE-B" EDITED: 2019/ 10/ 4
9-9. Hybrid system – if the
hybrid system does not start
S09AP07
The following are possible causes for the
system not starting. Check the following
and perform the appropriate procedure.
. The charge cable may be attached to
the vehicle.
. There is a possibility that the tempera-
ture of the high voltage battery is extremely
low (approximately below −228F (−308C)).
. The electronic key may not be function-
ing properly.
. There may not be sufficient fuel in the
vehicle’s tank.
. There may be a malfunction in the
immobilizer system.
. There may be a malfunction in the shift
control system.
. The hybrid system may be malfunction-
ing due to an electrical problem such as
electronic key battery depletion or a blown
fuse. However, depending on the type of
malfunction, an interim measure is avail-
able to start the hybrid system.
When the hybrid system does not start, the
following steps can be used as an interim
measure to start the hybrid system if the
push-button ignition switch is functioning
normally. Do not use this starting proce-
dure except in cases of emergency.
1. Apply the parking brake.
2. Turn the push-button ignition switch to
the “ACC” position.
3. Press and hold the switch for about 15
seconds while depressing the brake pedal
firmly.
Even if the hybrid system can be started
using the above steps, the system may be
malfunctioning. Have the vehicle in-
spected by your SUBARU dealer.
9-10. Fuel door – if the fuel
door cannot be opened
S09AP05
In the event that you cannot open the fuel
door by pressing the fuel door release
switch, you can open it from inside the
cargo area.
1. Remove the access cover at the
bottom of the rear right trim using a flat-
head screwdriver wrapped with vinyl tape
or a cloth.
Hybrid system – if the hybrid system does not start
402
Loading ...
Loading ...
Loading ...