Loading ...
Loading ...
Loading ...
HBG EVAPORATOR OPERATOR’S MANUAL
5
HBG • 8.913-990.0-K
9. When the machine is work ing, do not cover or place
in a closed space where ventilation is in suf fi cient.
Avoid in stall ing ma chines in small con fi ned ar eas.
Ad e quate ox y gen is need ed for the evap o ra tion pro-
cess. Standard minimum clearances for this type of
appliance is 18" from fl oor, sides and rear and 48"
from electrical control box. The minimum clearance
from the vent stack is 18". This appliance must be
installed on non-combustible fl oors.
10. The HBG and components will freeze if not in
op er a tion. In cold cli mates locate HBG in heated
en clo sure.
11. Run ning the system with out water damages the tank
fl oor and voids the war ran ty.
NOTE: Allow tank to cool before adding wastewater
or dam age will occur to tank fl oor due to ther mal
shock.
12. The HBG must be installed and train ing provided by
an au tho rized deal er.
13 Do not operate the equip ment in an unvented, en-
closed area. Car bon mon ox ide may ac cu mu late.
14. If you smell gas, shut off the gas
sup ply valve, ex tin guish any
open fl ame and test all joints
with a soap so lu tion. If the odor
per sists, call your gas sup pli er
im me di ate ly.
15. Only those liquid wastes
that have been approved by
WATER MAZE, and the prop er
regulatory agencies, should be
placed in the HBG ma chine. Test
methods as outlined in WA TER MAZE Pro fi le 3518
must be ob tained. NOTE: WA TER MAZE
is not li a ble
for the per for mance and the warranty will be void
when waste liq uids that are not test ed and ap proved
are in tro duced into the HBG.
16. Chemistry limitations include:
Maximum 1,000 mg/L chlo rides for 316L stain less
steel.
Maximum 40,000 mg/L chlo rides for AL-6XN
stainless steel pH be tween 7.0 and 9.0.
Initial oil concentration be tween 500 and 5,000
mg/L or a corrosion in hib i tor for car bon steel.
Deviations from these parameters must be ap proved
by Engineering.
ELECTRICAL SAFETY
Ground equipment before con nect ing to the elec tri cal
pow er sup ply.
Fail ure to ground the equip ment can
cause a se vere or fa tal elec tri cal
shock haz ard.
Do not ground to a gas sup ply line.
To avoid dangerous or fatal elec tri cal
shock, dis con nect the pow er to the
equip ment be fore work ing on any elec-
tri cal con nec tion or making any re pairs.
Supply voltage must be within ± 10%
of the name plate volt age. In cor rect volt age can cause
a fi re or seriously dam age the equip ment and void the
war ran ty. If in doubt, con sult a li censed elec tri cian.
Con nect the equipment to a ded i cat ed circuit break er.
DANGER: This machine is
equipped with an elec tron ic ig-
ni tion sys tem. Light ing of the
pi lot is ac com plished through
elec tron ic spark ignition. Do not
at tempt to light the ap pli ance
man u al ly as a burn in ju ry or elec-
tri cal shock may result.
WARNING
RISK OF EX PLO SION:
DO NOT USE WITH
FLAMMABLE
LIQUIDS.
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
If you do not follow these instructions exactly, a fi re or explosion
may result, causing property damage, personal injury or loss of
life.
A. This appliance has a pilot which must be electrically ignited.
When lighting the pilot, follow these instructions exactly.
B. Before lighting, smell all around the appliance area for gas. Be
sure to smell next to the fl oor because some gas is heavier than
air and will settle on the fl oor.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch. Do not use any phone in the
building.
Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fi re department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand, don’t
try to repair it.
Call a qualifi ed service technician. Attempted repair or use of
force may result in a fi re or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualifi ed service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
HAZ ARD OUS VOLTAGE
CAN SHOCK, BURN
OR CAUSE DEATH.
GROUND SYS TEM
BE FORE CON NECT ING
TO POW ER SUPPLY.
DANGER
HAS ELEC TRON IC
SPARK IG NI TION.
DO NOT AT TEMPT
TO LIGHT MAN U AL LY.
DANGER
Loading ...
Loading ...
Loading ...