Loading ...
Loading ...
Loading ...
10
HBG EVAPORATOR OPERATOR’S MANUAL
HBG • 8.913-990.0-K
ALARM STROBE INSTALLATION - Locate
a position in which to install the strobe light
assembly that will be visible to alert someone
of this alarm.
CAUTION: Disconnect Power Before
Servicing. From the terminal strip inside the
machine's electrical box, connect a black and
white 18 gauge wire (fi gure 1), then run them
through conduit to the Alarm Strobe Light with
Horn Assembly. These wires will be 120 volt!
Inside the strobe light assembly you will fi nd
4 screw terminals. Install the 2 jumper wires
included and wire per instructions provided with
the strobe light assembly.
Connect the black wire to terminal #4 and the
white wire to terminal #2 in the HBG electrical
box per fi gure 1.
ATTENTION! The alarm/strobe supplied with this
machine is specially designed to draw attention
to abnormal conditions and alert employees.
This device must be installed on the wall near
the machine in clear view of the operator. See
pages 6, 10 & 26 for instructions.
INSTALLING THE ALARM
STROBE LIGHT ON THE HBG
Figure 1
WB
120V
Field Wiring
PRE-START CHECK LIST
YES NO
Has gas supply been inspected by an
authorized contractor to meet local
codes?
Has air supply hose been connected
and adjusted?
Is machine shielded from moisture or
water spray?
Is the voltage correct and are the circuit
breaker and supply cord adequate
according to specifi cations and serial
plate notation?
Is the machine electrically grounded?
Is there ample wastewater supply?
Have all fl ammable liquids or gases
been removed from the installation
location?
Is there adequate gas supply for the
BTU rating of the burner?
Is incoming gas supply pressure to
the machine between 6-14 w.c.i. or 1/2
psig?
Has the proper gas regulator been
installed for pressure and volume?
Is the machine properly vented to allow
adequate fl ow?
Are the propane tanks large enough,
according to the rating of the machine,
to prevent freezing?
Have gas lines been checked for gas
leaks?
Have all operators using this machine
been instructed properly and have they
read the manual?
Has the machine been installed
according to the operator’s manual
instructions?
Has wastewater pH been adjusted
between 8 - 10?
CAUTION: If “NO” has been checked on any of the
above questions, do not operate the machine.
Loading ...
Loading ...
Loading ...