Loading ...
Loading ...
Loading ...
03 Your driving environment
Alcoguard*
03
108
* Option/accessory, for more information, see Introduction.
Result after breath test
Indicator lamp
(5) + Display text
Specification
Green lamp + Alco-
guard Approved
test
Start the engine - no
alcohol content
measured.
Yellow lamp + Alco-
guard Approved
test
Engine starting pos-
sible - measured
alcohol content is
above 0.1 promille
but below the limit
value in force
A
.
Red lamp + Disap-
proved test Wait 1
minute
Engine starting not
possible - measured
alcohol content is
above the limit value
in force
A
.
A
Limits vary between countries, so find out what limits apply.
See also the section entitled General information on the
Alcolock on page 107
NOTE
After a completed period of driving, the
engine can be restarted within 30 minutes
without a new breath test.
To bear in mind
Before the breath test
In order to obtain correct function and as accu-
rate a measurement result as possible:
•
Avoid eating or drinking approx.
5 minutes before the breath test.
•
Avoid excess windscreen washing - the
alcohol in the washer fluid may result in an
incorrect measurement result.
Change of driver
In order to ensure that a new breath test is car-
ried out in the event of a change of driver -
depress the switch (2) and the send button (3)
simultaneously for approx. 3 seconds. At
which point the car returns to start inhibition
mode and a new approved breath test is
required before starting the engine.
Calibration and service
The Alcolock must be checked and calibrated
at a workshop
1
every 12 months.
30 days before recalibration is necessary the
display shows
Alcoguard Calibr. required. If
calibration is not carried out within these 30
days then normal engine starting will be
blocked - only starting with the Bypass func-
tion will then be possible, see page 109 sec-
tion Emergency situation.
The message can be cleared by pressing the
send button (3) once. Otherwise it goes out on
its own after approx. 2 minutes but then reap-
pears each time the engine is started - only
recalibration at a workshop
1
can clear the mes-
sage permanently.
Cold or hot weather
The colder the weather the longer it takes
before the Alcolock is ready for use:
Temperature (ºC) Maximum heat-
ing time (sec-
onds)
+10 - +85 10
-5 - +10 60
-40 - -5 180
At temperatures below -20 ºC or above
+60 ºC the Alcolock requires additional power
supply. The display shows
Alcoguard insert
power cable
. In which case, connect the
power supply cable from the glovebox and wait
until indicator lamp (6) is green.
1
An authorised Volvo workshop is recommended.
Loading ...
Loading ...
Loading ...