Loading ...
Loading ...
Loading ...
26
English
Use
Master power switch (Fig. E-2)
The equipment is equipped with a master power switch
to shut down the equipment completely.
To start the equipment:
- Insert the mains plug into the equipment.
- Insert the mains plug into the wall socket.
- Set the master power switch to the on position.
To stop the equipment:
- Set the mains power switch to the off position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
Safety key (Fig. E-1)
The equipment is equipped with a safety key that
must be properly inserted into the console to start
the equipment. If you remove the safety key from the
console, the equipment will stop immediately.
- Insert the safety key into the slot in the console.
- Make sure that the clip of the safety key is properly
attached to your clothing.
Make sure that the clip is not removed from your
clothing before the safety key is removed from the
console.
Circuit breaker (Fig. E-2)
The equipment is equipped with a circuit breaker that
interrupts the circuit when the electricity load is above
the maximum capacity. When this occurs, the circuit
breaker must be pressed.
WARNING
• Before pressing the circuit breaker, remove the
mains plug from the equipment.
If the equipment shuts down, proceed as follows to
restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the equipment.
- Insert the mains plug into the equipment.
NOTE
• Some circuit breakers used in homes are not
rated for high inrush currents that can occur
when a treadmill is first turned on or even during
normal use. If your treadmill is tripping the circuit
breaker (even though it is the proper current
rating and the treadmill is the only appliance on
the circuit) but the circuit breaker on the treadmill
itself does not trip, you will need to replace
the breaker with a high inrush type. This is not
a warranty defect. This is a condition we as a
manufacture have no ability to control.
Console (Fig. F)
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when the
equipment is not used for 4 minutes.
Jog wheel and Buttons
Back, Stop button:
- Move back to previous window
- Stop the active training
User/Settings:
- Press this button to enter User/Setting mode screen
- This button is of no use during workout
Speed +
- Increases the speed (0.8~20 Kph).
- Pressing once increases the speed 0,1 kph.
- Pressing and holding for two seconds will increase
the speed faster.
- Scroll programs and change values in programming
mode.
Speed -:
- Decreases the speed (0.8~20 Kph).
- Pressing once decreases the speed 0,1 kph.
- Pressing and holding for two seconds will decrease
the speed faster.
- Scroll programs and change values in programming
mode.
Incline +
- Increases the incline (0%~15% ±1%).
- This button is also used to scroll the programs.
Incline -:
- Decreases the incline(0%~15% ±1%).
- This button is also used to scroll the programs.
Jog wheel: (Fig. E-03)
Turn functions:
- Choose workout mode in main menu
- User/setting mode option selection
- Choose working item on the setting screen
- Increase or decrease the setting value
- Adjusting target value (high/low) during workout
Loading ...
Loading ...
Loading ...