Loading ...
Loading ...
Loading ...
• Program will continue when electricity
supply is stable - The mains supply is
unstable. Wait until the mains supply
is stable.
• A water leak has been detected - The
anti-flood device is on. Disconnect the
appliance and close the water tap.
Contact the Authorised Service
Centre.
• Cleaning cycle recommended - Run
the Machine Clean program as
described in ‘Programs’ chapter. If
the cleaning program is postponed,
the message keeps on popping up
during next uses until it is run.
If the cleaning program is
postponed, the message
keeps on popping up
during next uses until it is
run.
18.2 Possible failures
Problem Possible solution
The program does not
start.
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the Start/Pause has been touched.
• If the delay start is set, cancel the setting or wait for the end
of countdown.
• Deactivate the Child Lock function if it is on.
The appliance does not
fill with water properly.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is cor‐
rect.
• Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to "Care and cleaning".
The appliance fills with
water and drains immedi‐
ately
• Make sure that the drain hose is in the correct position. The
hose may be positioned too low. Refer to "Installation in‐
struction".
ENGLISH 51
Loading ...
Loading ...
Loading ...