AEG LF9A1612AC 10kg 9000 Series Front Load Washing Machine

User Manual - Page 50

For LF9A1612AC.

PDF File Manual, 60 pages, Read Online | Download pdf file

LF9A1612AC photo
Loading ...
Loading ...
Loading ...
45°
20°
17.9 Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the program to drain the water.
17.10 Frost precautions
If the appliance is installed in an area
where the temperature can reach the
values around 0° C or drop below,
remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than
0 °C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
18. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
18.1 Introduction
WARNING!
Deactivate the appliance
before carrying out any
check.
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the "Possible failures" table). If
the problem persists, contact the
Authorised Service Centre.
In case of major problems, the buzzer
operates, an alarm message pops and
the Start/Pause button may flash
continuously, e.g.:
Check that the water inlet tap is open
- The appliance does not fill with
water properly.
Check that the drain filter is not
clogged - The appliance does not
drain the water.
Check that the door is properly closed
- The appliance door is open or not
closed correctly. Please check the
door!
If the appliance is
overloaded, remove
some items from the
drum and/or keep the
door pressed while
pressing the
Start/Pause
button until the indicator
stops flashing (see
the picture below).
www.aeg.com50
Loading ...
Loading ...
Loading ...