Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
31
ArtNo.320-0002a Proplus oven door side screws
Fig.8-8
ArtNo.320-0007 Oven door hinge adjustment 2
Fig.8-7
ArtNo.320-0006 Oven door hinge adjustment 1
Fig.8-6
Eect of hinge adjustment - exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
If it is not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear. Undo the screws
securing the electric cover to the back sheet and remove the
cover. Disconnect the terminals from the rear.
Fit new elements and reassemble in the reverse order. Check
the operation of the grill.
9. To Remove the Grill Door
Remove the left-hand side panel (see 1). Remove the control
panel (see 3). Remove the centre cover strip (5 screws, 2 top, 2
bottom, 1 in middle). Remove the two countersunk screws (1
each side) securing the grill hinge arms to the front of the grill
chamber.
Note: The arms are spring tensioned. Carefully remove the grill
door. Retain the gaskets.
Reassemble in reverse order, ensuring that the gasket is tted
between the hinge arm and the front of the grill chamber.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.
Lift the element out carefully, disconnecting the leads from
the element terminals (noting their position). If it is not
possible to disconnect the leads in this way, pull the cooker
forward to gain access to the rear, remove the screws securing
the electric cover to the back sheet, remove the cover and
disconnect the terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the grill.
10. To Replace an Oven Door
Open the oven door. Support the door and remove the two
screws securing the upper hinge and gasket to the cooker
front (Fig.8-4). Remove the door from the lower hinge by
lifting slightly and moving outwards (Fig.8-5).
The door is heavy, so take care.
Reassemble in reverse order.
11. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to alter
the angle of the door (Fig.8-6). Loosen the bottom hinge xing
screws and use the notch and a at bladed screwdriver to move
the position of the hinge to set the hinge position (Fig.8-7).
Retighten the hinge screws.
12. To Replace the Main Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel xing
screws from the door sides – two each side (Fig.8-8).
Carefully lift o the outer door panel.
Remove the door handle from the panel by unscrewing the
two retaining nuts. Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in reverse order.
13. To Change the Main Oven Door Latch
Remove the outer door panel (see 12). Remove screws ‘B’ that
hold the latch assembly to the inner door panel (Fig.8-9). Fit
the new catch and reassemble in reverse order.
Verify the door operation.
ArtNo.320-0004 Oven door keep
Fig.8-10
ArtNo.320-0003 Oven door latch
B
Fig.8-9
ArtNo.320-0001 Door hinges
1
ArtNo.320-0001 Door hinges
2
Fig.8-4 Fig.8-5
Loading ...
Loading ...
Loading ...