Loading ...
Loading ...
Loading ...
en Faults and what to do about them
34
Information on the display panel
Display Cause/remedy
è lights up ■ The temperature is too high. Wait until the temperature drops.
■ The water level is too high. It is not possible to add laundry. Run the Spin pro-
gramme to reduce the water level, if necessary.
è flashes ■ Laundry may be caught. Open and close the door again and press the A but-
ton.
■ If necessary, push the door closed or remove some laundry and then push it
closed again.
■ If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
r lights up The water pressure is too low.
r flashes ■ Turn on the cold water tap fully,
■ Supply hose kinked/trapped,
■ Clean the filter. ~ Page 32
“ :‚ ‰ ■ The drain pump is blocked. Clean the drain pump. ~ Page 31
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 32
“ :„ ƒ Alternating display with “Ÿš when programme is finished, indicating the laundry
inside are unbalanced. The washing machines’ unbalanced load detection system
can not adjust the imbalance.To protect the mechanical systems, the machine will
not achieve the highest spin speed, and the laundry can not be spinned completely.
Please wash small and large items of laundry together.
E The childproof lock is activated – deactivate it.
Å* lights up Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
The indicator light ¢
for the Drum clean
programme* flashes
Run the Drum clean programme or a 60 °C programme to clean and care for the
drum and the outer tub.
Notes
■ Run the programme without laundry.
■ Switching the information signal on/off ~ Page 29
Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call the after-sales service. ~ Page 36
* depending on the model
Loading ...
Loading ...
Loading ...