Loading ...
Loading ...
Loading ...
Positioning and connecting en
15
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any residues from the
production and to remove water that
may be left over from the test, run the
first wash cycle without any laundry.
Notes
■ The washing machine must be
correctly installed and connected.
~ Page 10
■ Never use a damaged machine.
Inform customer services.
1. Check the machine.
2. Remove the protective foil from the
work top and the control panel.
3. Connect the mains plug.
4. Turn on the tap.
5. Close the door (do not load any
laundry).
6. Depending on the model, select
Drum clean 90 °C or
Cottons 90 °C program.
7. Open the detergent drawer.
8. Pour approximately 1 litre of water
into compartment II.
9. Pour standard detergent into
compartment II.
Note: To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for wool or delicates.
10.Close the detergent drawer.
11.Press the A button.
12.When the program ends, switch off
the appliance.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
~ "Filter in the water supply is
blocked" on page 32
3. Drain the remaining detergent
solution.
~ "Detergent solution pump
blocked" on page 31
4. Disconnect the washing machine
from the mains.
5. Remove the hoses.
Installing the transport bolts:
Remove four covers and the rear cover.
Insert and tighten the transport bolts.
Before switching on the appliance
again:
Notes
■ The transport bolts must be
removed. ~ Page 11
■ To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Spin program.
Loading ...
Loading ...
Loading ...