Loading ...
Loading ...
Loading ...
en Programme default settings
22
rpm 0
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting 0: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting - - -: (Rinse Stop) = no final
spin. The laundry stays in the water after
the final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To continue/end the program see
~ Page 27
Note: The maximum speed that can be
set depends on the model and
programme that has been selected.
Finished in ñ
Before starting the programme, you
can preselect the programme end
("Ready in" time) in hourly increments (h
= hour) up to a maximum of 24 hours.
To do this:
1. Select a programme.
The programme duration is
displayed for the selected
programme, e.g. ƒ:„‹
(hours:minutes).
2. Press the Finished in ñ button
repeatedly until the required number
of hours is displayed.
3. Press the A button.
The door will be locked.
The selected number of hours (e.g.
‰ h) is shown in the display panel
and counts down until the wash
programme starts. The duration of
the programme is then displayed.
Note: The programme duration is
included in the selected “Ready in”
time.
During the timer count-down, you can
change the preselected number of
hours as follows:
1. Press the A button.
2. Use the Finished in ñ button to
change the number of hours.
3. Press the A button.
During the timer count-down you can
add or remove laundry as required.
Note: The length of the programme is
automatically adjusted when the
programme is running.
Certain factors can affect the
programme length, e.g.:
■ Programme settings,
■ Detergent dosage (additional rinse
cycles if required due to foaming),
■ Load size/type of textiles (longer
washing for higher load and for
textiles which absorb more water),
■ Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■ Fluctuations in power supply,
■ Water pressure (infeeding speed).
Loading ...
Loading ...
Loading ...