Loading ...
Loading ...
Loading ...
Cleaning and maintenance en
31
3. Clean the detergent dispenser tray
and insert with water and a brush,
and dry it. Clean the inside of the
housing as well.
4. Fit the insert and lock it in place
(push the cylinder onto the guide
pin).
5. Push in the detergent drawer.
Note: Leave the detergent drawer open
so that any residual water can
evaporate.
Cleaning the measuring aid
*
for liquid detergent
If it contains liquid detergent residue:
1. Hold the mearsuring aid, pull the
cover upward and disconnect them.
2. Clean the measuring aid and cover
with water and brush.
3. Install the cover back to the
measuring aid. Pay attention to the
assemble mark, and press the cover
until click sounds.
Detergent solution pump
blocked
Note: Turn the tap off to prevent more
water from flowing in and to ensure that
it is drained via the pump.
:Warning
Risk of scalding!
Washing water is hot when washing at
high temperatures. You may be scalded
if you touch the hot washing water.
Allow the washing water to cool down.
1. Pull out the mains plug.
2. Open and remove the maintenance
cover.
3. Carefully unscrew the pump cover -
do not remove it completely. Let the
water drain into a shallow container.
Repeat the operation until there is no
water left.
4. Remove the pump cover. Remove
foreign material/fluff from inside the
pump. Clean the interior, pump
cover thread and pump housing (the
fan impeller in the detergent-solution
pump must be able to rotate).
5. Refit the pump cover, ensuring it fits
tightly. Handle should be vertical.
6. Insert the maintenance cover and
close it.
* depending on the model
Loading ...
Loading ...
Loading ...