Loading ...
Loading ...
Loading ...
10
ENGLISH
• When carrying the suspended, unit pass the ropes between legs of
base panel under the unit.
• Always lift the unit with ropes attached at four points so that impact
is not applied to the unit.
• Attach the ropes to the unit at an angle of 40° or less.
• Use only accessories and parts which are of the designated specifica-
tion when installing.
Air outlet grille Intake hole
Corner
Handle
Always hold the unit by the corners, as holding
it by the side intake holes on the casing may
cause them to deform.
Sub line
40° or less
A
WARNING
CAUTION
Be very careful while carrying the product.
•
Do not have only one person carry product if it is more than
20kg(44lbs).
• PP bands are used to pack some products. Do not use them as
a mean for transportation because they are dangerous.
• Do not touch heat exchanger fins with your bare hands. Other-
wise you may get a cut in your hands.
• Tear plastic packaging bag and scrap it so that children cannot
play with it. Otherwise plastic packaging bag may suffocate chil-
dren to death.
• When carrying in Outdoor Unit, be sure to support it at four
points. Carrying in and lifting with 3-point support may make
Outdoor Unit unstable, resulting in a fall.
• Use 2 belts of at least 8m(26.2 ft) long.
• Place extra cloth or boards in the locations where the casing
comes in contact with the sling to prevent damage.
•
Hoist the unit making sure it is being lifted at its center of gravity.
!
• Fix the unit tightly with bolts as shown below so that unit will not fall
down due to earthquake or gust.
• Use the H-beam support as a base support
• Noise and vibration may occur from the floor or wall since vibration is
transferred through the installation part depending on installation sta-
tus. Thus, use anti-vibration materials (cushion pad) fully (The base
pad shall be more than 200 mm(7-7/8 inch)).
At least 200mm
(7-7/8 inch)
Foundation for Installation
• Install at places where it can endure the weight and vibration/noise
of the outdoor unit.
• The outdoor unit supports at the bottom shall have width of at least
100mm(3-15/16inch) under the Unit’s legs before being fixed.
• The outdoor unit supports should have minimum height of 200mm(7-
7/8inch).
• Anchor bolts must be inserted at least 75mm(2-15/16inch).
At least 100mm
(3-15/16inch)
At least 100mm
(3-15/16inch)
At least 100mm
(
3-15/16inch)
At least 100mm
(3-15/16inch)
At least 100mm
(3-15/16inch)
At least 100mm
(3-15/16inch)
Center of the Unit
For outdoor units
should not be
supported only
by the corner
supports.
Center of the Unit
a
be
e
cd
ARUB060GSS4
a 920(36-7/32)
b 618(24-11/32)
c 330(13)
d 360(14-3/16)
e 151(5-15/16)
[Unit : mm(inch)]
The location of the Anchor bolts
INSTALLATIONLIFTING METHOD
1,MFL69717904,영영 18. 8. 29. 영영 2:49 Page 10
Loading ...
Loading ...
Loading ...