Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 43
Seatback Bolster Adjustment
The front driver and passenger seatback bolsters
can be extended outward, or retracted inward by
pushing the bolster adjustment button located in
the center of the seatback switch.
Push the top of the button to extend the bolsters,
or push the bottom of the button to retract the
bolsters.
Seatback Bolster Adjustment Button
Cushion Extender
The cushion can be extended forward a few inches
(centimeters) to increase thigh support. Push the
cushion extender switch forward or rearward to
extend or retract the cushion. Release the switch
when the desired position has been reached.
Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger
seats may also be equipped with power lumbar.
The power lumbar switch is located on the
outboard side of the power seat. Push the switch
forward to increase the lumbar support. Push the
switch rearward to decrease the lumbar support.
Pushing upward or downward on the switch will
raise and lower the position of the support.
Power Lumbar Switch
Easy Entry/Exit Seat — If Equipped
This feature provides automatic driver seat
positioning to enhance driver mobility when
entering and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you place the vehicle’s ignition in the OFF position.
When you place the vehicle’s ignition in the OFF
position, the driver seat will move about
2.4 inches (6 cm) rearward if the driver seat
position is greater than or equal to 2.7 inches
(6.8 cm) forward of the rear stop. The seat will
return to its previously set position when you
place the vehicle’s ignition in the ON/RUN posi-
tion.
The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than 0.9 of
an inch (2.3 cm) forward of the rear stop. At this
position, there is no benefit to the driver by
moving the seat for Easy Exit or Easy Entry.
When enabled in Uconnect Settings, Easy Entry
and Easy Exit positions are stored in each memory
setting profile Ú page 34.
NOTE:
The Easy Entry/Exit feature is enabled or disabled
within the Uconnect system Ú page 204.
1 — Extend Seatback Bolsters
2 — Retract Seatback Bolsters
2
22_WL_OM_EN_USC_t.book Page 43
Loading ...
Loading ...
Loading ...