Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 319
NOTE:
Proper placement for the front and rear jacking
locations is critical. See the following images for
proper jacking locations.
Jacking Locations
3. For the front axle, place the jack on the body
flange just behind the front tire as indicated by
the triangular lift point symbol on the sill
molding. Do not raise the vehicle until you are
sure the jack is fully engaged.
Front Lifting Point
NOTE:
The jack must be placed straight on with handle
facing outwards.
Front Jacking Location
4. For a rear tire, place the jack in the slot on the
rear tie-down bracket, just forward of the rear
tire (as indicated by the triangular lift point
symbol on the sill molding). Do not raise the
vehicle until you are sure the jack is fully
engaged.
Rear Lifting Point
CAUTION!
Do NOT raise the vehicle by the body side sill
molding. Be sure the jack is placed in the proper
engagement location on the inside of the panel.
Damage of the vehicle may occur if the
procedure is not properly followed.
7
22_WL_OM_EN_USC_t.book Page 319
Loading ...
Loading ...
Loading ...