Loading ...
Loading ...
Loading ...
31
USING THE ROTISSERIE
To light the rotisserie burner before cooking
The location of the rotisserie burner makes it more susceptible to strong wind conditions, more so
than the protected grill burners. For this reason you should avoid operating the rotisserie during
windy conditions. As an added safety feature we’ve equipped the burner with an automatic safety
valve which will not allow gas to flow to the rotisserie burner unless the following conditions are
present with the knob on:
1 The safety valve button is pressed, and held down.
2 The safety valve thermocouple has been sufficientlyheated to keep safety valve open.
Open the hood. Push and hold the ignition button. You’ll hear a snapping sound. Turn the burner
knob to “HI”. Engage the safety valve button and continue to hold until the burner is lit. Once lit,
turn burner knob to desired setting. If the burner does not light within four to five seconds, release
the safety valve button and turn the burner knob to “OFF” and wait five minutes before trying again.
If relighting a hot burner, wait five minutes.
Never leave the burner knob on if rotisserie is not in use.
Never light the grill burners under the rotisserie while the rear rotisserie burner is lit.
IMPORTANT!
Electrical Earthing Instructions: this appliance (rotisserie motor) is equipped with a three-prong
(earthing) plug for your protection against shock hazard and should be plugged directly into a
properly earthed three-prong receptacle or a three-prong earthed extension cord rated for the power
of the rotisserie motor and approved for outdoor use. Do not cut or remove the earthing prong from
this plug. Use only a residual current device (RCD) protected circuit.
The rotisserie motor must be electrically earthed in accordance with local codes. The rotisserie
motor should be supplied through a residual current device (RCD) having a rated residual operating
current not exceeding 30 mA. Keep the rotisserie motor electric cord away from the heated surfaces
of the grill. When not in use, remove and store the motor in a dry location. To protect against
electric shock, do not immerse the cord or plug in water or other liquid. Unplug rotisserie unit from
the outlet when not in use and before cleaning. Allow the rotisserie to cool before putting on or
taking off parts.
Manual lighting
To manually light the rotisserie, place a butane lighter
near the tip of the thermocouple as shown in Fig. 26. Turn
the burner knob to “HI”. Hold the safety valve button in
for about four to five seconds or until the burner remains
lit. Once lit, turn burner knob to desired setting. If the
burner does not light within four or five seconds, release
the safety valve button and turn the burner knob to “OFF”
and wait five minutes before trying again.
IMPORTANT!
Keep hands and face away from front of burner! Stand to
the side when lighting. Once lit move hand away quickly.
Fig. 26
Loading ...
Loading ...
Loading ...