Loading ...
Loading ...
Loading ...
25
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation.
Grill lighting instructions
Push and hold the ignition button, turn the selected burner knob to “SEAR”. If burner does not light
in four to five seconds, turn knob “OFF” and wait five minutes before trying again to allow for any
accumulated gas to dissipate.
Grill match lighting
If the burner will not light after several attempts then the burner
can be match lit. If you’ve just attempted to light the burner
with the ignition, allow five minutes for any accumulated gas to
dissipate. Keep your face as far away from the grill as possible and
pass a lit match over the hole located on the top left for burner on
the left, or the right hole for the right burner (Fig. 19). Push and
turn the control knob which is centred on the burner where the
lit match is located, to “SEAR”. If the burner does not light in four
seconds, turn the knob off, wait five minutes and try again.
Once the left or right burner is lit, the adjacent burner can be lit by
the cross-lighting method. For centre burners to cross light, light
the adjacent far left or right burner using the standard or match
light procedure. Push and turn the control knob for the desired
centre burner to “SEAR”. The gas will be ignited by the adjacent
burner’s flame. If the burner does not light in four seconds, turn
knob off, wait five minutes and try again.
IMPORTANT!
In certain types of LPG cylinders, improper lighting procedures can cause the LPG cylinder flow
control to activate, resulting in reduced heat output. If this is suspected, to reset flow control, shut
off all burner controls and LPG cylinder valve, wait 30 seconds, then turn LPG cylinder valve on
extremely slowly, wait five (5) seconds and push and hold the ignition button and turn burner valve
on to “SEAR”.
1 All knobs must be in the
OFF position.
2 Attach regulator hose
assembly to the tank.
3 Open the LP tank valve.
(Two full turns min).
Resetting the flow control
Grill lighting instructions
IMPORTANT!
Open the grill hood and/or remove the top grate cover from side burner (for 48BQR) before lighting.
Turn all knobs to “OFF”. Turn the main gas supply on slowly. If you smell gas, shut off gas supply and
call for service.
Fig. 19
USING THE GRILL
Lighting Instructions
Loading ...
Loading ...
Loading ...