Loading ...
Loading ...
Loading ...
18
INSTALLATION
Gas Hook-up
LP tank restraint for built in installation
If the grill is to be installed in a built-in application, then the grill must be installed in accordance
with the built–in installation guidelines.
If you intend to operate your built-in grill on LPG gas utilising a minimum 9 kg cylinder, then the
built-in LPG cylinder restraint must be installed prior to initial use of the grill. If you do not have
one please contact DCS by Fisher & Paykel for information on obtaining one. See section ‘Service’
for contact details.
The following steps will illustrate how to properly locate and install the LPG cylinder restraint
within the built-in enclosure.
IMPORTANT!
The grill comes with the LPG Regulator/Hose assembly installed at the factory. The assembly, along
with the entire grill system, is leak tested.
Do not remove the Regulator/Hose assembly from the grill during installation.
Fig. 13
Centre of cylinder restraint must be
placed within this area to avoid causing
stress on the LPG regulator hose
connection.
The maximum distance from the center
of the manifold cut out to the center of
the tank restraint is 457mm.
Center of manifold
cut out projected to
floor of the island.
457mm max
Loading ...
Loading ...
Loading ...