Loading ...
Loading ...
Loading ...
24
Storage
Store the product between uses and/or during periods of extended inactivity or when transporting. Proceed as follows:
• Turn the control knob to the OFF position.
• Disconnect the LPG cylinder.
• Store the product upright in an area sheltered from direct exposure to inclement weather (rain, sleet, hail, wind,
snow, dust and debris).
• If desired, cover the product to protect the exterior surfaces and to help prevent build-up in air passages.
• Never leave LPG cylinder exposed to direct sunlight or excessive heat.
NOTICE
Wait until the product is cool before covering.
Service
Only a qualified service person should repair the gas passages and associated components.
CAUTION
Always allow the product to cool before attempting service.
Troubleshooting
Problem Possible cause Solution
Pilot does not light.
Note: The product operates at
reduced efficiency below 5 °F.
Cylinder valve is closed. Open valve.
Blockage in orifice or pilot tube. Clean or replace orifice or pilot tube.
Air in gas line. Open gas line and bleed it (pressing control
knob in) for not more than 1 to 2 minutes or
until you smell gas.
Low gas pressure with cylinder
valve fully open.
Turn cylinder valve OFF and replace
cylinder.
Piezo ignition fails. Use match to light pilot; obtain new igniter
and replace.
Pilot does not stay lit. Dirt built up around pilot. Clean dirt from around pilot.
Connection between gas valve
and pilot assembly is loose.
Tighten connection and perform leak
check.
Thermocouple is not operating
correctly.
Replace thermocouple.
Burner does not light. LPG cylinder is frosted over. Wait until the LPG cylinder warms up and
becomes unfrosted.
Blockage in orifice. Clear blockage.
Control knob is not in ON position. Turn control knob to ON.
Burner flame is low. Gas pressure is low. Turn cylinder valve OFF and replace
cylinder.
Outdoor temperature is less than
5°F and tank is less than 1/4 full.
Use a full cylinder.
Carbon build-up.
Thick black smoke.
Dirt or film on reflector and
burner screen (inside control
box (8)).
Clean reflector and burner screen.
Blockage in burner. Remove blockage and clean burner inside
and outside.*
Only qualified service persons using approved accessories shall replace components and service internal parts of
the product.
Loading ...
Loading ...