Loading ...
Loading ...
Loading ...
21
4. If after repeating steps 2-3, the product does not light, then:
– Lift the flame tube (12) and prop it to give at least 1/2” of clearance below the tube.
– Push in control knob and turn counterclockwise to PILOT (Figure 3).
– As you hold in the control knob, place long stem lighter beneath the flame tube to light the pilot (Figure 4).
5. Once the pilot flame is lit, turn the control knob counterclockwise to HIGH or whichever heat level you prefer.
6. To turn the product off, turn the control knob clockwise to PILOT position. Then depress the control knob and
turn clockwise to OFF position. Close the valve on your LPG cylinder when the product is not in use.
Figure 3 Figure 4 Figure 5
NOTICE
If pilot fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should
pass before attempting to light.
CAUTION
Avoid inhaling fumes emitted from the product’s first use. Smoke and odor from the burning of
oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately
30minutes. The product should not produce thick black smoke.
NOTICE
The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn
the control knob to the PILOT position. Then, turn the knob to the level of heat desired.
NOTICE
Under normal conditions, the height of flame at HIGH setting is approximately 2/3 of the height of
the flame tube, and the height of the flame at LOW setting is approximately 1/3 of the height of the
flame tube. The flame is stable and bright. It should not create an audible noise or black smoke. If
you notice noise or smoke, this is abnormal operation.
Normal flame
Abnormal flame
WARNING
Risk of injury! Be careful when attempting to manually ignite this product. Holding in the control
knob for more than 10 seconds before igniting the gas will cause a ball of flame upon ignition.
During Operation
The flame should be mostly blue and yellow. If excessive flame or smoke is detected, turn off the product and consult
“Troubleshooting”.
Re-lighting
NOTICE
For your safety, the control knob cannot be turned off without first depressing the control knob in the
PILOT position and then rotating it to the OFF position.
1. Turn the control knob to OFF.
2. Wait at least 5 minutes, to let gas dissipate, before attempting to relight pilot.
Repeat the previously described steps about lighting (Lighting Instructions).
WARNING
Risk of burning! The product will be hot after use. Handle with extreme care. Certain materials
or items, when stored under the product, will be subjected to radiant heat and could be seriously
damaged.
Loading ...
Loading ...
Loading ...