Loading ...
Loading ...
Loading ...
6
SECTION 1 Set-Up & First Brew
Setting up Your Brewer
1. Unwrap cord and plug the brewer into a
grounded outlet. Remove all pieces of
packing tape.
2. Ensure BREW/DRAIN Selector Knob is set
to BREW (fig. 1).
3. Place a large mug (10 oz. minimum) on
the Drip Tray Plate.
4. Remove the Water Reservoir from the brewer
by first removing the Water Reservoir Lid (fig. 2),
then lifting Reservoir straight up and away from
the brewer (may be tight). Rinse with fresh water.
5. Fill Water Reservoir with bottled or filtered
water. The water level should reach the line just
below the top edge of the clear viewing area.
Do not overfill.
IMPorTanT: You cannot use your Keurig
®
brewer until
it has been set-up for its first use as set forth below.
noTe: If the brewer has been exposed to
temperatures below freezing, allow brewer at
least two hours to reach room temperature
before brewing. A frozen or extremely cold brewer
will not operate.
6. Place Water Reservoir base into the left side of
the brewer and be sure the Water Reservoir
Lock Tabs engage with the Lock Tab Slots on
the brewer (fig. 3). Replace Water Reservoir Lid.
7. Press POWER Button found on upper right
panel of the brewer. The green POWER Light
will illuminate. NOTE: A K-Cup
®
pack should not
be used for this sequence
.
NOTE: If the Water Reservoir is empty or not
correctly placed on the brewer, the blue ADD
WATER Light will illuminate. The BREW Button
will not be activated until water is added to the
Water Reservoir and the Water Reservoir
is in place.
8.
The green brew size indicator lights on the LED
Control Center will flash to indicate the brewer
needs to be set-up. Make sure the Handle is
lowered completely before continuing.
9. Press the flashing blue BREW Button.
10 . The brewer will automatically heat the water.
This will take about 4 minutes. During the
heating period, the red HEATING Light will
illuminate. Once the water is heated, the red
HEATING Light will turn off and the lights
indicating the brew size will illuminate.
NOTE: Do not lift Handle during this heating period.
P
U
S
H
T
O
B
R
E
W
BREW
AUTO-OFF
POWER
DRAIN BREWER
HEATING
DESCALE
ADD WATER
fig.
3
fig.
4
fig.
1
fig.
2
BREW DRAIN
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...