Loading ...
Loading ...
Loading ...
EN
©2019 Hestan Commercial Corporation
16
ELECTRICAL SUPPLY
Important: This appliance must be electrically grounded in accordance with local codes, or in the
absence of local codes with the National Electrical Code,
ANSI/NFPA 70-1990
.
Appliances equipped with a flexible electrical supply cord are provided with a three-prong grounding
plug. It is imperative that this plug be connected to a properly grounded three-prong receptacle. If
the receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding
prong from this plug.
The Power Burner is designed for 120 volt AC power and must be plugged into a Ground Fault
Circuit Interrupter (GFCI) protected circuit. Do not connect the Power Burner to the electrical
supply until after gas connections have been made and leak checks have been performed.
KEEP ANY ELECTRICAL CORD AND FUEL SUPPLY HOSE AWAY FROM ANY HEATED
SURFACES.
1. To protect against electric shock, do not immerse cord or plugs in water or other liquid.
2. Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or
taking off parts.
3. Do not operate any outdoor cooking gas appliance with a damaged cord or plug, or after the
appliance malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
4. Do not let the cord hang over the edge of a table or touch hot surfaces.
5. Do not use an outdoor cooking gas appliance for purposes other than intended.
6. Use only a Ground Fault Circuit Interrupter (GFCI) protected circuit with this outdoor cooking
gas appliance.
7. Never remove the grounding prong or use with a 2-prong ground adapter.
8. Use only extension cords with a 3-prong grounding plug, rated for the power of the equipment,
and approved for outdoor use with a W-A marking.
BURNER ADJUSTMENTS
The center burner of the Hestan Power Burner is similar to many residential gas cooktops. They do
not have any adjustments, except for the correct orifices, and adjustment of the low setting on the
valve. The octagonal burner also has no adjustment, except the correct orifice and adjustment of the
air-shutter.
BURNER FLAME ADJUSTMENT
Each Power Burner is tested and adjusted at the factory prior to shipment. The proper orifice for
the gas type, and the air-fuel adjustment was made at this time. However, variations in the local
gas supply, the elevation where you live, converting from one gas type to another, and other factors
might make it necessary to adjust the burner flames.
The flames of the burners should be visually checked and compared with the figures on the next
page. Flames should be blue and stable with no yellow tips (LP units will have some yellow tipping).
There should be no excessive noise or flame lifting. If any of these conditions exist, remove the
burner cap and check if dirt, debris, spider webs, etc., are blocking the center venturi hole, or the
individual burner ports. The occasional orange flame that quickly goes away is usually a small
amount of dust or water condensation which is burning off - this is normal.
The octagonal burner should also be periodically checked for blocked ports, debris, spider webs, etc.
Cleaning instructions are described in the CLEANING AND MAINTENANCE section.
GAS AND ELECTRICAL CONNECTIONS
(continued)
Loading ...
Loading ...
Loading ...