Loading ...
Loading ...
Loading ...
Australia
Remove the control panel (see section 2) and hotplate
top (see section 3). Open the appropriate oven door and
remove the oven shelves.
Right hand oven
Remove the oven roof. Remove the two fixings that secure
the thermostat phial cover. Unclip the thermostat phial
from the clips in the oven back panel and remove it from
the top rear of the oven.
Left hand oven
Remove the two screws holding the thermostat phial to the
oven fan cover at the rear of the oven. Pull the unit forward
to access the rear of the cooker. Remove both rear cover
boxes by removing the fixing screws and lifting clear.
Feed the thermostat capillary clear of the oven. Disconnect
the wires from the thermostat and undo the two fixings
that secure the control to the mounting plate. Fit the
replacement and re-assemble in reverse order. Ensure that
the phial is clipped to the oven rear, positioned centrally
between the clips. Check that the thermostat functions
correctly.
Remove the control panel (see section 2) and hotplate top
(see section 3). Disconnect the wiring from the controller.
Remove the two screws holding the switch/controller to
mounting panel. Fit the new controller and re-assemble in
reverse order. Check for correct operation.
Remove the hotplate top (see section 3). Unplug the FSD
lead from the rear of the tap. Undo the compression fitting
at the rear of the tap. Remove the fixings that secure the
tap to the gas rail. Remove the tap. Remove and discard the
gasket seal. Fit the new gasket seal to the replacement tap.
Re-assemble in reverse order.
Ensure that the valve is adjusted for correct gas operation.
Check that the cooker is gas sound. Check hotplate ignition.
Remove the burner cap and head. Remove the old jet. Fit
the new orifice.
NB The Wok burner has 2 orifices.
Re-assemble in reverse order. Check that the appliance is
gas sound.
Lift off the cooktop pan supports and remove the burner
cap. Remove the screw holding the electrode. Pull the
electrode vertically up sufficiently to grip the lead between
thumb and forefinger. Pull off the electrode, but keep
hold of the lead. Fit the new electrode to the lead. Fix the
electrode in the burner with the screw. Replace the burner
cap. Check the burner ignition. Replace the pan supports.
Remove the hotplate top (see section 3). Remove the
control panel (see section 2).
Outer Hotplate Burners
The burners are mounted in two’s on cross supports.
Disconnect the burner feed pipes at the burners. Remove
the screw at the front holding the cross support. Slide the
support to the right to release it from the rear location.
Lift the cross support and burners clear. The burners
are fixed to the cross supports with screws underneath.
Remove the appropriate burner and fit the new one.
Re-assemble in reverse order. Check that the burner
operation is satisfactory.
Wok burners
Disconnect the burner feed pipes at the burner. Fit the new
one and re-assemble in reverse order. Check that the burner
operation is satisfactory.
Open the left hand oven door and remove the two screws
from the bottom edge of the grill door.
Open the grill door, support grill door outer panel, and
remove the two screws from the top inner face of the grill
door.
Re-assemble in reverse order.
Open the oven door and remove the Handyrack (where
fitted) by springing one side out of the bracket on the door
and sliding the other side free. The door is heavy - take care.
Open the oven door and loosen the two top hinge screws.
Loading ...
Loading ...
Loading ...