Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Australia
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Unfold the rear edge of the pack base tray. Open the
grill door and right hand oven door so that you can get
a good grip on the bottom of the fascia panel as you
move the oven:
Grip under the fascia panel and lift the front of the
cooker slightly:
Carefully push the cooker backwards off the pack base.
Remove the pack base tray. Position the cooker close
to its final position, leaving just enough space to get
behind it.
If you need to move the cooker once it has been
connected, then you need to unplug it and, having
gripped under the fascia panel and lifted the front
of the cooker slightly (as shown above), you need to
check behind the cooker to ensure that the gas hose is
not caught. As you progress, make sure that both the
electricity cable and gas hose always have sufficient
slack to allow the cooker to move.
Release the stability chain as you ease the cooker
out. When you replace the cooker, don’t forget to refit
the chain and also
check behind to make sure that the
electricity cable and gas hose are not caught or trapped.
If the appliance is to be converted to LP gas, carry out
the conversion at this point. See the conversion section
of these instructions.
It is recommended that you use a spirit level on a shelf
in one of the ovens to check for level. Ensure that the
cooker in its intended position, taking care not to twist
it within the gap between the kitchen units, as damage
may occur to the cooker or the units. The front feet
and rear rollers can be adjusted to level the cooker.
To adjust the height of the rear of the cooker, use the
levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker. To set the front feet,
simply turn the bases to raise or lower them.
Remove the 4mm Allen screws from the doors with
the hexagon key tool. Use the screws to fit the door
handles.
Loading ...
Loading ...
Loading ...