Loading ...
Loading ...
Loading ...
Australia
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
another hose, it is still mandatory to fit the stability
bracket and restraining chain.
After completing the gas connection, ensure that
the cooker is gas sound with a pressure test (see the
following sections).
The adjustable spring loaded governor is pre-set to give
a nominal pressure of 1kPa on NG. Connect to the Rp
1/2 inlet on the underside of the governor (just above B
on the previous figure).
Pull the cooker forward, if necessary, to gain access to
the rear of the cooker. The gas pressure test point is
accessible on the connector block that comes out of the
governor at the top rear of the cooker.
Remove the test nipple screw and fit a pressure gauge
to the test point. Turn on and light two of the hotplate
burners.
See the data badge and the section at
the back of this book for test pressures.
Conversion from Natural Gas to
LP Gas
This cooker is supplied ready for use on natural gas.
A conversion kit for propane gas is supplied with the
cooker. Any conversion to propane must be performed
by a competent person. Following conversion, the
installation must comply with the relevant regulations
and also the local electricity supply company
requirements.
Standard burner Wok burner
A jet, B internal injector, C external injector
Remove the burner caps and heads. Remove the old jets
and then fit the new jets. Re-assemble in reverse order.
Pull off all the control knobs.
If the hand rail has
been fitted, remove it
by removing the plastic
blanking plugs, followed by
the two end bracket fixing
screws.
Remove the two cross-
headed screws that were
hidden by the hand rail
end brackets.
Open the oven door and grill door and remove the
fixing screws underneath the control panel.
Lower the fascia panel clear of the top retaining tags.
Turn the bypass screw on each gas control clockwise to
the stop:
A tap bypass screw
Unscrew the governor's brass top. There is a plastic
snap-in converter device in the base of the brass top:
Loading ...
Loading ...
Loading ...