Loading ...
Loading ...
Loading ...
EN
17
TROUBLESHOOTING
Your dishwasher may not work properly.
Before contacting the After-sales Service, check if the problem can be solved by going through the following list.
PROBLEMS POSSIBLE CAUSES SOLUTIONS
Display shows:
CHECK SALT! or
ADD SALT
Salt reservoir is empty.
Rell reservoir with salt (see page 4).
Adjust water hardness (see page 4).
Display shows:
CHECK RINSE AID! or
ADD RINSE AID
Rinse aid dispenser is empty. Rell dispenser with rinse aid (see page 4).
... is not working / will not
start.
The appliance must be switched on. Check the household circuit fuse if there is no power supply.
The appliance door doesn’t close. Check if the appliance door is closed.
“Start Delay” option is ON.
Check whether the „Start Delay” option has been selected. If it has, the
appliance will start once the set time has elapsed. If necessary, Reset
the current cycle by switching OFF the dishwasher, then switch it on
again, select a new cycle, press START and close the door.
Display shows: F6
symbol on the display
indicators
Water pressure is too low.
The water tap must be fully open during water inlet (minimum capaci-
ty: 0.5 litres per minute).
Kinked water inlet hose or cloged
inlet lters.
The water inlet hose must not be kinked and the inlet lter in the water
tap connector must not be dirty or clogged.
Display shows: F3
Dirty lters. Clean the lters.
Kinked drain hose. The drain hose must not be kinked.
Syphon hose connection closed.
The closure disk of the syphon hose connection
must be removed.
Display shows: F2
Dirty lters or spray arms. Clean lters and spray arms.
Too little water in the appliance
system.
Concave items (e.g. bowls, cups) must be arranged
facing downwards in the rack.
Drain hose incorrectly tted.
The drain hose must be tted correctly (for high mounted appliances,
leave min. 200 - 400mm from the lower edge of the appliance) - see
Installation.
High level of foam inside.
Repeat without detergent or wait until foam
disappears..
Water pressure is too low.
The water tap must be fully open during water inlet (minimum capaci-
ty: 0.5 litres per minute).
Kinked water inlet hose or cloged
inlet lters.
The water inlet hose must not be kinked and the inlet lter in the water
tap connector must not be dirty or clogged.
Display shows:
PRESS START AND
CLOSE THE DOOR
Door is not closed within
4 seconds of button press.
Press again and close the appliance door within 4 seconds.
Display shows:
OPEN AND CLOSE
THE DOOR
The door was not open between
cycles.
Unload appliance (if not unloaded before), open and close the door.
Display shows: Fx
Appliance has technical defect.
Call customer service (state fault displayed).
Close the water tap.
Loading ...
Loading ...
Loading ...