Loading ...
Loading ...
Loading ...
30
Figure 38
Figure 40
EXPAND WORKTABLE AREA
This saw is designed to allow for large capacity cuts up to
(2 x 16 inch). In order to make these cuts you will need to
configure your saw appropriately.
DO NOT use an auxiliary table board which
will not fully support the workpiece during cutting operation.
1. Loosen the fence lock knob
A
. Slide the upper
(adjustable) fence completely out of its track and set to
the side. See Figure 38. (Both upper fences need to be
removed).
2. Flip the back fence support tabs (
C
&
D
) into
position. Tabs
D
are on both the left and right sides of
the lower (xed) fence. Tab
C
only exists on the right
side of the lower (xed) fence. These will function as
your workpiece backstop. See Figure 40.
3. You will need to add a 2 x 12 inches (1 1/2 x 11 5/8
inches) auxiliary table board
E
to support your large
capacity workpiece
F
. See Figure 40.
NOTE: The Auxiliary Table Board should be as wide as the lower
(xed) fence and secured to the lower fence using wood screws,
see Figure 39.
4. Use the support tabs (
C
&
D
) to support the back
of your workpiece before making any cuts.
OPERATION
Figure 39
E
F
D
C
TIGHTEN
LOOSEN
B
A
Loading ...
Loading ...
Loading ...