Loading ...
Loading ...
Loading ...
22
OPERATION
Figure 24
CUTTING WARPED MATERIAL
See Figure 24.
When attempting to cut warped material, the CONVEX face
should be against the fence.
See Figure 25.
NEVER position a piece of warped material with the CONCAVE
face or edge against the fence. It will pinch the blade near the
completion of the cut.
To avoid a kickback and to avoid serious
personal injury, NEVER position the CONCAVE edge of bowed
or warped material against the fence.
Figure 25
• DO NOT allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sucient enough to
inict serious personal injury.
• ALWAYS wear eye protection with side shields and marked to comply with ANSI Z87
.1 Failure to do so could result in objects
being thrown into your eyes, resulting in possible serious personal injury.
• DO NOT use any attachments or accessories not recommended by the manufacturer of this tool
. The use of attachments or
accessories not recommended can result in serious personal injury.
• ALWAYS clamp or bolt the compound miter saw to a workbench before starting any cutting operation.
• NEVER operate the miter saw on the oor or in a crouched position
. Failure to heed this warning can result in serious personal
injury.
• ALWAYS tighten the miter lock knob and bevel lock handle securely before making a cut. Failure to do so could result in serious
injury due to movement of the control arm or miter table while making a cut
.
• KEEP hands outside the no hands zone, at least 4 inches from the blade in order to avoid serious personal injury.
• NEVER perform any cutting operation freehand (without holding workpiece securely against the fence)
. The blade could grab
the workpiece if it slips or twists.
• When using a work clamp or C-clamp to secure the workpiece, clamp workpiece on one side of the blade only
. The workpiece
MUST remain free on one side of the blade to prevent the blade from binding in workpiece. The workpiece binding the blade will
cause motor stalling and kickback. This situation could cause an accident resulting in serious personal injury.
• NEVER move the workpiece or make adjustment to any cutting angle while the saw is running and the blade is rotating
. Any slip
can result in contact with the blade causing serious personal injury.
• DO NOT force the blade against the workpiece when cutting. Forcing the blade will cause a drop in motor RPM and increase the
risk of overheating the saw blade tips
.
You may use this tool for the following purposes:
• Bevel cutting and compound cutting for crown moldings,
etc
.
• Cross cutting wood.
• Cross cutting for moldings, door casings, picture frames,
etc
.
NOTE: This saw is for cutting wood or wood-like products
. The
blade provided is not acceptable for cutting other materials.
Loading ...
Loading ...
Loading ...