Loading ...
Loading ...
Loading ...
NOTICE
Page 14
3. Connect the other end of the hose to the side port (Fig. 5).
4. Remove the primer cover on the pump (Fig. 10) then ll the pump with water. Place
the cover back onto the funnel, tighten.
6. Move the ow valves to the DRAW position (Fig. 2).
7. Make sure the spray bar and side port valves are CLOSED (Figs. 3 & 4).
CAUTION:CAUTION:
In order to ll the tank with the DRAW function, you must have at least one inch of water
above the outlet pipe of the tank. Water below this level may not be sucient to prime
the suction hose.
PUMP DAMAGE
8. Using the STARTING THE ENGINE instructions, start the engine of the pump.
9. Move the side port valve to OPEN (Fig. 4). You may notice air bubbles in the tank as
the water starts to ow. If the pump fails to prime, stop the engine and repeat step 4.
10. Wait until the tank is lled to the required level.
11. Once the tank is lled, move the side port valve to CLOSED.
12. Shut o the engine by using the SHUTDOWN instructions.
13. Move the tank valve to the CLOSED position
.
Fig. 10
We recommended having a lter (not included) on the end of the suction hose. Not using
a lter can introduce debris into the pump and the tank that may cause damage. Always
place the lter at a depth where air cannot be introduced into the system, but do not allow
it to sit on the muddy bottom of the source.
5. Move the tank valve to OPEN (Fig. 3).
14. Disconnect the hose then place the cover on the hose bard; lock into place (Fi
g. 6).
PUMP DAMAGE
Loading ...
Loading ...
Loading ...