Loading ...
Loading ...
Loading ...
User Manual of DS-6700 Series Audio/Video Encoder
39
7.3.4 Configuring PPPoE Settings
Your device also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Click the Remote Configuration > Network Settings > PPPoE Settings to enter the PPPoE settings
interface:
Figure 7.14 PPPoE Settings
2. Check the PPPoE checkbox to enable this feature.
3. Enter User Name, Password, and Confirm Password for PPPoE access.
Note: The User Name and Password should be assigned by your ISP.
4. Click the Save button to save and exit.
7.3.5 Configuring Email Settings
Purpose:
The device can be configured to send an Email notification to all designated receivers if an alarm event is detected,
e.g., motion detection event, video loss, tamper-proof, etc.
Before you start
1. Before configuring the Email settings, the device must be connected to a local area network (LAN) that
maintains an SMTP mail server. The network must also be connected to either an intranet or the Internet
depending on the location of the e-mail accounts to which you want to send notification.
2. Please configure the DNS Server settings under Remote Settings>Network Settings>TCP/IP before using
the Email function.
Steps:
1. Enter the Basic Network Settings (Remote Configuration > Network Settings > TCP/IP) to set the IPv4
Address, IPv4 Subnet Mask, IPv4 Default Gateway and the Preferred DNS Server.
2. Click the Remote Configuration > Network Settings > Email to enter the Email settings interface:
Loading ...
Loading ...
Loading ...