Rigol DS1074Z-S-PLUS DS1000Z user manual

Loading ...

Chapter 13 Signal Source RIGOL

DS1000Z User Guide 13-11

6. Align Phase

The align phase operation is for the two channels. Pressing AlignPhase will

re-configure the two channels to output according to the preset frequency and

phase. For two signals of which the frequencies are the same or are multiples,

this operation can align their phases. Acquire the waveforms of the two channels

using the oscilloscope and display the waveforms stably. After switching the

channel status, the phase deviation between the two waveforms is changed. At

this point, press AlignPhase and the phase deviation shown on the oscilloscope

will restore to the current phase deviation between the two waveforms

automatically.

7. Select waveform

Select the arbitrary waveform in the internal or external memory. For the detailed

operation, please refer to the introduction in "To Select Waveform".

8. Create waveform

Users define their own arbitrary waveform. For the detailed operation, please

refer to the introduction in "To Create Waveform".

9. Edit waveform

Edit the arbitrary waveform stored. For the detailed operation, please refer to the

introduction in "To Edit Waveform".

10. Modulation

Press Src1Mod to enter the modulation setting interface. For detailed

introduction of the modulation function, please refer to "

Modulation".

11. Set the impedance

Press Impedance to set the output impedance of the signal generator. It can be

set to "HighZ" or "50Ω".

The following section introduces how "To Select Waveform", "To Create

Waveform" and "To Edit Waveform".

To Select Waveform

Users can load the waveform stored or recall the channel signal waveform according

to their needs.

 Load

Select arbitrary waveforms in the internal or external memory (D disk) for output.

Press Select  Load, use to select the desired waveform. For the detailed

operation, please refer to the introduction in "Store and Recall".

 Channel Signal

Select the signals of analog channel (CH1-CH4) turned on currently for output.

Loading ...

Rigol DS1074Z-S-PLUS DS1074Z-S+ oscilloscope