Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE - 11991477A485/D
e
open with the loading wand inside. The
appliance cyclically discharges certain
quantities of water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
End of water circuit cleaning
8. After completion of the cleaning process the
request to drain the water is shown on the
display.
9. Clean and dry any residual water inside the
oven cavity.
Reservoir draining
10.Open the door
11. Place a jug or container on the open door.
12.Remove the loading wand from its holder.
13.Press the START button to start draining
the water into the jug (or container).
14.Wait for the end of the drain flow.
When complete, the display will indicate that
the residual water removal process is complete.
15.Touch the CONFIRM button.
16. Shake the loading wand in order to remove
any remaining water.
17.Place the loading wand back in its holder.
18.Remove the jug (or container).
19. Drain the water from the jug.
20.Close the door.
Sanitization
Sanitization with steam allows to remove the last
residues of descaling from the hydraulic circuit.
1. set a 70% combined steam function lasting
at least half an hour.
2. Fill the jug with clean water.
3. Open the appliance door.
4. Rest the jug on the open door.
5. Remove the loading wand from its holder.
6. Place the end of the tube at the bottom of
the jug (or container).
7. Press the start button to start filling the
appliance reservoir with water.
8. When finished, shake the loading wand to
remove any water residue.
9. Place the loading wand back in its holder.
10.Remove the jug (or container).
11.Close the door.
12. Touch the START button to start the
selected steam function.
13.Wait for the function to be executed until the
end.
14. At the end of the function, drain the reservoir
as described above.
15.Wait for the end of the drain flow.
16.Drain the water from the jug.
17.Open the door.
18.Wipe off any spillage of water in the oven
cavity with a cloth or sponge.
19.Close the door.
Reservoir calibration
Over time, the quantities of water in the reservoir
may not be read correctly by the appliance
sensor. In this case, the functionality of the
appliance sensor can be restored to an optimal
condition.
It is recommended to carry out the
cleaning process of the reservoir and
the water circuit a couple of times.
You can also use a cleaning solution
instead of water. In this case it is
advisable to carry out at least a couple
of water rinses afterwards, following the
instructions in this chapter.
Take care: wait for the oven cavity to
cool down.
This function allows you to calibrate the
correct reading of the quantity of water
(or other liquid) inside the reservoir.
Loading ...
Loading ...
Loading ...