Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE - 11591477A485/D
e
2. Carefully pull the frame towards the inside of
the oven cavity to unhook it from front
housing A.
3. Remove the frame from the rear pin B
located at the bottom of the side wall.
4. Repeat the operation for the frame placed
on the other side wall.
To refit the rack/tray support frames:
1. Slide the rear part of the frame into the
housing under the pin B located at the
bottom of the side wall.
2. Replace the front part of the frame in
housing A on the side wall near the opening
of the oven cavity.
3. Screw in the front fixing pin (you can help
yourself with a tool, e.g. a coin).
4. Repeat the operation for the frame placed
on the other side wall.
Vapor Clean (on some models only)
Preliminary operations
Before starting the Vapo r Clean function:
• Completely remove all accessories from
inside the oven.
• If present, remove the temperature probe.
• If present, remove the self-cleaning panels.
• Close the door.
• During the assisted cleaning cycle, wash the
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
Vapor Clean cycle setting
See General safety instructions.
The Vapor Clean function is an assisted
cleaning procedure which facilitates the
removal of dirt. Thanks to this process, it
is possible to clean the inside of the
oven very easily. The dirt residues are
softened by the heat and water vapour
for easier removal afterwards.
If the internal temperature is higher than
expected, the function is not activated.
Let the appliance cool down before
activating the function.
The duration and temperature of the
Vapor Clean function cannot be
changed by the user.
Loading ...
Loading ...
Loading ...