Loading ...
Loading ...
Loading ...
SDS6000A Series Digital Oscilloscope User Manual
1 2 6 int.siglent.com
Touch the SourceB Setting region to set the edge trigger source, threshold, and
slope. Touch the Limit Range and Upper/Lower Value region to set the delay
time condition.
16.5.14 Setup/Hold Trigger
Clock source and data source need to be set in setup/hold trigger setting. The
set-up time starts when the data signal crosses the trigger level and ends when
the specified clock edge arrives. The holding time starts when the specified
clock edge arrives and ends when the data signal crosses the trigger level again
(as shown in the figure below). When the set-up time or hold time meets the
preset time limit conditions, the oscilloscope will trigger.
Touch the CLK Setting region to set the clock source, threshold, and slope;
Touch the Data Setting region to set the data source, threshold, and state.
Loading ...
Loading ...
Loading ...