FLUKE 7109A-P-156 User Manual for the Fluke 7109A-P-156 Portable Calibration Bath with Process Electronics, -25°C to 140°C

Loading ...

6109A/7109A

Operators Manual

• Bath Calibration is the date the Product was calibrated.

• TEMP1 adjusts the temperature accuracy at the low end of the Product’s

temperature range.

• TEMP2 adjusts the temperature accuracy at the middle of the Product’s

temperature range.

• TEMP3 adjusts the temperature accuracy at the high end of the Product’s

temperature range.

• Cutout Mode temporarily disables the software cutout to facilitate testing

the hardware cutout. The setting is always Normal after power on.

• Typical Stir Power is a reference used to determine whether the load on

the stir motor has changed because of increased fluid viscosity (see

Diagnostics). It is up to the operator to set this value to the observed Stir

Power under normal conditions.

(Setup > Instrument > More > Service)  Input Calibration (7109A-P and

6109A-P only)

Adjust the measurement accuracy of the Input Module.

This menu requires the password to change any of the settings.

• Input Calibration is the date the Input Module was calibrated.

• REF1C0 adjusts the accuracy resistance measurements at 0 Ω.

• REF1C100 adjusts the accuracy of resistance measurements at 100 Ω.

• TCC0 adjusts the accuracy of the thermocouple measurements at 0 mV.

• TCC100 adjusts the accuracy of the thermocouple measurements at

100 mV.

• TCCRJ adjusts the accuracy of the thermocouple reference junction.

• mAC4 adjusts the accuracy of current measurements at 4 mA.

• mAC22 adjusts the accuracy of current measurements at 22 mA.

(Setup)  Probe (Models 7109A-P and 6109A-P)

Configure temperature probes connected to the Input Module.

The Probe screen shows the present configuration.

(Setup > Probe)  Reference Probe

View or change the reference probe configuration.

If the reference probe connector contains a programmed memory device

(INFO-CON), the probe coefficients are automatically transferred to the

Product when the reference probe is plugged in. If the probe does not

contain programmed memory, the probe coefficients must be entered

manually.

1.888.610.7664 sales@GlobalTestSupply.com

Fluke-Direct.com

Loading ...

FLUKE 7109A-P-156 Portable Calibration Bath with Process Electronics, -25°C to 140°C