Loading ...
Loading ...
Loading ...
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC 37
PROBLEM CAUSE SOLUTION
Pole saw does
not cut properly.
◾
Insufcient chain tension.
◾
Loosen the quick chain-tension
adjust knob at least one turn
counterclockwise rst and then fully
tighten it clockwise until the chain is
correctly tensioned.
◾
The bar and chain are
skewed and not parallel to
the housing.
◾
Remove the battery pack and reinstall
the bar and saw chain according to
the section "REPLACING THE BAR
AND CHAIN". Always remember to
keep the bar and chain parallel to
the mounting surface with one hand
before installing the side cover.
◾
Dull chain.
◾
Sharpen the chain cutters, following
the section “HOW TO SHARPEN THE
CUTTERS”.
◾
Chain installed backwards.
◾
Remove the battery pack and reinstall
the saw chain, following the section
“REPLACING THE BAR AND CHAIN”.
◾
Worn chain.
◾
Remove the battery pack and replace
the chain following the section
“REPLACING THE BAR AND CHAIN”.
◾
Dry or excessively stretched
chain.
◾
Check the oil level. Rell the oil tank if
necessary.
◾
Chain not in bar groove.
◾
Remove the battery pack and reinstall
the saw chain, following the section
“REPLACING THE BAR AND CHAIN”.
Bar and chain
run hot and
smoke.
◾
Chain oil tank is empty.
◾
Filling bar and chain lubricant.
◾
Debris in guide bar groove.
◾
Clear the debris in the groove.
◾
Chain cutters are dull.
◾
Sharpen chain cutters by following
the section “HOW TO SHARPEN THE
CUTTERS”.
Loading ...
Loading ...
Loading ...