Loading ...
Loading ...
Loading ...
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC22
NOTICE: The pole saw is not lled with oil at the time of purchase. It is essential
to ll the tank with chain oil before use. Operating the pole saw without chain oil or
when the oil level is below the 'MIN' mark will result in damage to the pole saw. Chain
life and cutting capacity depend on optimum lubrication. The chain is automatically
lubricated with chain oil during operation, if there is sufcient oil in the reservoir. Oil
level should also be checked after every 20 minutes of use and relled as needed.
1. Remove the battery pack from the power head.
2. Clean the oil-tank cap and the area around it to ensure that no dirt falls into the
oil tank.
3. Lay the pole saw on a rm, at
surface, so that the oil tank cap is
facing upwards. Rotate the oil tank
knob counterclockwise to remove it
(Fig. 10).
4. Carefully pour the bar and chain oil
into the tank until it lls to the tank
neck. Be careful not to let the oil
spill from the opening. Wipe off any
excess oil.
NOTICE:
◾
Use EGO authorized bar and chain oil (Model# AOL3200) for best results. It is
specially designed to provide low friction and faster cuts.
◾
Never use oil or other lubricants not specically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾
Check the oil level frequently and rell as needed.
◾
Do not use dirty, used or other contaminated oil. Damage may occur to the bar or
chain.
◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the machine for a long period of time, be sure the chain is lightly
lubricated; this will prevent rust on the chain and bar sprocket.
10
Oil Tank Cap
Loading ...
Loading ...
Loading ...