Loading ...
Loading ...
Loading ...
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC 35
◾
In addition, the guide bar has a
sprocket at its tip. The sprocket
must be lubricated weekly with a
grease syringe to extend the guide
bar life. Use a grease syringe to
lubricate weekly with chain oil by
means of the lubricating hole
(Fig. 29). Turn the guide bar and
check that the lubrication holes
and chain groove are free from
impurities.
Reversing the Guide Bar
1. Remove the guide bar and chain
from the pole saw following the
“REPLACING THE BAR AND
CHAIN” section.
2. Remove the chain from the guide
bar, the Phillips head screw (M3X6)
on the other side of the guide bar
and the adjustment plate (Fig. 30).
3. Turn the guide bar over (Fig. 31).
The bottom of the bar will be on the
top.
4. Install the adjustment plate on
the new side of the guide bar and
tighten it with the Phillips head
screw.
5. Replace the chain on the bar.
6. Reassemble the guide bar and chain onto the pole saw according to the
“REPLACING THE BAR AND CHAIN” section.
29
Lubricating Hole
Sprocket in Guide-bar Tip
31
30
Saw Chain
Guide Bar
Adjustment Plate
Phillips Head Screw
Loading ...
Loading ...
Loading ...