FLUKE 2062 User Manual for the Fluke 2062 Advanced Pro Wire Tracer Kit, CAT IV 600 V, 600 V AC/DC

Loading ...

Wire Tracer Receiver and Transmitter

Set up the Transmitter

Clamp Connection

Note

Because the Clamp does not have a direct connection to a conductive wire, the signal

may not be strong enough for the Receiver to detect very far from the Clamp. When

possible use test leads to make a direct connection to a conductive wire.

 Warning

To prevent possible electrical shock, fire, or personal injury, read all safety

information in the i400 AC Clamp Instructions before you use the Clamp.

To connect the Transmitter to a wire with the Clamp (see Figure 6):

1. Connect the tests leads of the Clamp to the Transmitter. The polarity does not matter.

2. Connect the Clamp around the wire.

Figure 6. The Clamp Connection

Set up the Transmitter

With the Transmitter connected to a circuit and turned on, the Transmitter generates a signal

on a wire and detects the voltage on the wire. Based on the voltage detected, the Transmitter

automatically selects energized or de-energized mode. Loop mode only generates a signal on

de-energized wires in a closed circuit.

2000T

RANSMITTER

1.888.610.7664 sales@GlobalTestSupply.com

Fluke-Direct.com

Loading ...

FLUKE 2062 Advanced Pro Wire Tracer Kit, CAT IV 600 V, 600 V AC/DC