Hikvision DS-K1T502DBFWX-C User Manual

Loading ...

RS-485 Address

Set the RS-485 Address according to your actual needs.

Note

If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set

the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address

according to the door No.

Baud Rate

The baud rate when the devices are communicang via the RS-485 protocol.

Data Bit

The data bit when the devices are communicang via the RS-485 protocol.

Stop Bit

The stop bit when the devices are communicang via the RS-485 protocol.

Parity/Flow Ctrl/Communicaon Mode

Enabled by default.

Output Type

Set the output type according to your actual needs.

9.4.10 Intercom

Device ID Sengs

The device can be used as a door staon, or outer door staon. You should set the device No.

before usage.

Steps

Tap

→ Intercom → Device ID Sengs .

Set the following parameters.

Device Type

The device can be used as a door

staon or outer door staon. Select a device type from the

drop-down list.

Note

If you change the device type, you should reboot the device.

Period No.

Set the device period No.

Building No.

DS-K1T502 Series Access Control Terminal User Manual

Loading ...

Hikvision DS-K1T502DBFWX-C Access Control Terminal