Loading ...
Loading ...
Loading ...
Export
When the oscilloscope is in "STOP" state, you can export the time and its
corresponding decoded data in the event table.
In Decode menu, click or tap Export, then the save setting interface is displayed. You
can export the data to the internal memory or the external USB storage device (only
when detected) in *.csv format. For details, refer to
Store and Load
.
Interpret the Decoded LIN Data
• Break (Sync Break): expressed in Hex, identified as "Break:".
• SYNC (Sync): expressed in Hex, identified as "SYNC:".
• ID (Frame ID): expressed in Hex, identified as "ID:".
• Data (Data): Its display format is the same as that of the bus data (Hex, Dec, Bin,
or ASCII), identified as "Data:".
• Checksum (check sum): expressed in Hex, identified as "Checksum:". When errors
occur, it is displayed as a red patch.
• Wakeup (wake up symbol): identified as "Wakeup:".
18.6 CAN Decoding
The oscilloscope samples the CAN signal at the specified sample position, and judges
each data point to be logic "1" or logic "0" according to the preset threshold level.
You need to specify the CAN signal type and sample position.
In the
Decode menu, click or tap the drop-down button of Bus Type to select CAN,
then configure the parameters for CAN decoding.
Figure 18.15 CAN Decoding Menu
Protocol Decoding
DHO900 User Guide
214
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Loading ...
Loading ...
Loading ...