Loading ...
Loading ...
Loading ...
9. The Control Panel
The LCD display illuminates automatically when the trigger switch is depressed and switches o after 20 seconds of
inactivity. The tool battery level is displayed at the top of the display.
– 17 –
EN
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
(34)
9.1 Output Selection
The grease gun can be programmed to operate in either
low or high output mode.
To switch between output modes, press and release
button B (34). The active mode is shown on the LCD
display (28) (29).
9.2 LED Worklight
19 Fig.
(33)
(15)
The grease gun is tted with an LED worklight (15) that
can be switched on and o as required.
To switch on the worklight, press and release button A
(33). Press the button again to switch o the light.
9.3 Monitoring Grease Flow
The LCD display indicates how much lubricant has been
dispensed since the reading was last reset. This value can
be displayed in either grams (g) or ounces (oz).
To switch between measurement units, press and hold
button A (33) for up to ten seconds. To reset the reading,
press and hold button B (34) for up to ten seconds.
An approximate indication of the remaining lubricant is
also displayed. When no more grease is available in the
tube, the LCD display enters warning mode; see 10.4
LCD Warning Mode and Safety Cut-Outs.
9.4 LCD Warning Mode and Safety Cut-
Outs
The grease gun will automatically detect the following
issues:
• The tool is drawing more than 40A of current from the
battery.
• An air pocket in the grease tube is preventing the tool
from functioning.
When these issues occur, the LCD display ashes red and
the motor stops automatically. Check the hose, grease
tube and grease tube head for blockages and expel any
air pockets that have accumulated.
26. LCD display
27. Battery level
28. High output mode
29. Low output mode
30. Remaining grease level
31. Grease output reading
32. Grease output units
33. Button A
34. Button B
Loading ...
Loading ...
Loading ...