Loading ...
Loading ...
Loading ...
7. Loading the Grease Gun
2. Ensure that the open end of the grease tube is free
from any dust or debris, and push the plunger handle
inwards as far as possible.
11 Fig.
3. Ensure that the open end of the grease tube is free
from any dust or debris, and push the plunger handle
inwards as far as possible.
4. Fully insert the open end of the grease tube into the
lubricant.
5. Slowly pull the plunger handle outwards until it is
fully drawn, ensuring that the end of the tube is
completely covered at all times.
Important: If a break in the suction occurs at any
time during loading, empty the tube into the
container and begin loading again.
12 Fig.
(17)
(25)
(24)
6. When the plunger rod (17) is fully extended, latch the
groove (24) into the plunger lock slot (25) and wipe
away any excess grease from the open end of the
tube.
7. Screw the grease tube tightly back into the grease
tube head and clean any excess grease from the
grease tube exterior.
8. Prime the grease gun; see 8.5 Priming the Grease
Gun and Expelling Air Pockets.
9. Slide the rod all the way into the grease tube.
10. Reset the control panel display; see 10.3 Using the
Control Panel.
7.4 Filling the Grease Gun Using a Filler
Pump
Important: A ller pump (not supplied) must be tted to
the bulk container in order to use this method to load the
grease gun.
1. Push the handle inwards as far as possible.
2. Insert the bulk ller nipple into the ller pump socket.
3. Operate the bulk ller until the plunger rod locking
groove (24) aligns with the locking slot (25).
CAUTION!
DO NOT overll the grease tube.
4. Release the plunger rod from the locking slot and
slide the rod all the way into the grease tube.
5. Reset the control panel display; see 10.3 Monitoring
Grease Flow.
7.5 Priming the Grease Gun and Expelling
Air Pockets
Important: The grease gun must be primed every time
the grease gun is loaded in order to purge any air pockets
from the grease tube. The battery pack must be installed
in order to fully prime the tool.
This process can be used to prime the tool after loading
and to expel air pockets that may form during use.
1. Load the grease gun using the chosen method and
ensure that the plunger rod (17) is fully extended and
locked into place.
– 14 –
Loading ...
Loading ...
Loading ...