Loading ...
Loading ...
Loading ...
8. Operating Instructions
8.1 Operation
1. Insert a suitable battery pack (see 7.2 Inserting and
Removing the Battery).
14 Fig.
2. Set the output mode as required (see 10.1 Output
Selection).
3. Remove the hose cap (12) and attach the hose
coupler (13) to an appropriate grease tting.
Important: Ensure that the coupler ts snugly around
the grease tting and hold it in place to prevent
disconnection
15 Fig.
(13)
4. Squeeze the trigger switch (19) to dispense the
lubricant.
16 Fig.
(19)
5. Remove the hose coupler from the grease tting.
Important: DO NOT pull on the hose to disconnect
the coupler.
8.2 The Strap
The grease gun can be used with the strap supplied for
hands-free transportation during use. Attach the strap
clips to the top and bottom loops of the grease bun body.
17 Fig.
8.3 The Safety Valve
The safety valve (18) is preset at 10,000psi (±1,000psi)
before shipment. If this pressure level is reached, the
grease gun will not dispense grease.
If this occurs, clean around the safety valve and check for
blockages and debris in the grease tube (8), grease tube
head (9) and hose (11) and ensure that the target bearing
is not clogged. Blockages within the grease gun can also
be cleared by fully loosening the air vent valve (1) and
using a brush to clean inside the opening.
Important: DO NOT adjust this valve under any
circumstances. Doing so will not improve the grease gun
performance, will invalidate your warranty and may lead
to injury.
– 16 –
Loading ...
Loading ...
Loading ...