Loading ...
Loading ...
Loading ...
Alarm and Hourly Time
Signal
Q1
An alarm does not sound.
Is the watch’s battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
l
Charging
The crown is pulled out.
The alarm will not sound while the crown
is pulled out. Push the crown back in to its
normal position.
Other than the above.
The alarm’s settings may not be
configured. Configure the alarm settings.
l
Configuring Alarm Settings
Q2
The hourly time signal does not
sound.
Is the watch’s battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
l
Charging
The crown is pulled out.
The hourly time signal will not sound while
the crown is pulled out. Push the crown
back in to its normal position.
Other than the above.
The hourly time signal may be disabled.
Enable the hourly time signal.
l
Enabling the Hourly Time Signal
Hand Movement and Watch
Screen Indications
Q1
I don’t know what mode the watch is
in.
You can determine the current mode by
checking the watch display. Use (B) to
navigate between modes.
l
Navigating Between Modes
Q2
The second hand is jumping at two-
second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
l
Charging
Q3
All hands are stopped and buttons do
not work.
The battery is dead. Keep the watch exposed
to light until it recharges sufficiently.
l
Charging
Q4
The hands suddenly start moving at
high speed.
This is due to the reason (or one of the
reasons) below, and does not indicate
malfunction. Simply wait until normal hand
movement resumes.
●
The watch is recovering from a power
saving state.
l
Power Saving Function
●
A time calibration signal is being received
and the time setting is being adjusted.
l
Time Adjustment Using a Time Signal
●
Watch is connected with a phone to adjust
its time setting.
l
Auto Time Adjustment
Q5
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q6
Why is the current time indicated by
the watch is off by a certain amount
of time (nine hours, three hours and
15 minutes, etc.)?
The city setting is not correct. Select the
correct setting.
l
Setting a Home City
Q7
The current time indicated by the
watch is off by one hour or 30
minutes.
The summer time setting may not be correct.
Select the correct setting.
l
Setting a Home City
Q8
The time indicated by the hands is
different from the displayed time.
Strong magnetism or impact can cause the
hands to go out of alignment. Adjust hand
alignment.
l
Adjusting Hand Alignment
●
Check the information below to find out how
to align the hands manually.
l
Hand Alignment Adjustment
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for at least
two minutes after pulling out the crown
(approximately 30 minutes in the case of hand
alignment), crown operations will
automatically become disabled. If that
happens, push the crown back in and then pull
it out again.
l
Using the Crown
Watch Operation Guide 5713
57
Loading ...