Loading ...
Loading ...
Loading ...
3.
X
Hold down (C) for at least two seconds.
Release the button when [INDICATE]
starts to flash, and the second hand points
to .
When a location information receive
operation is successful while the watch is
connected with a phone, [INDICATE] will
change to [OK].
After two seconds, the distance from your
current location to the recorded location
appears on the display, and the bearing
hand indicates the bearing to the
destination.
*2
North indication North indication
Bearing to destination Bearing to destination
After two seconds
*1
Second
hand
Distance from your current location
*1
[
] starts to flash on the display when the
bearing hand indication is within 30
degrees of the bearing to the destination.
*2
[G] is shown on the display when you are
within 80 meters of the destination. [G] will
disappear from the display if you move to
a distance of 161 meters or more from the
destination.
4.
X
Check the display distance and the
bearing to your destination on the display.
Note
●
Location Indicator remains enabled for
three minutes.
●
The watch connects with the phone
and acquires location information
every 10 seconds or each time (C) is
pressed, and uses the acquired
information to refresh the distance and
the bearing up to the point stored in
Location Memory.
●
Location Indicator will become
disabled automatically about three
minutes after it is enabled. You can
also disable it manually by pressing
any button besides (C) or (E).
●
Pressing (C) or (E) while Location
Indicator is enabled causes it to remain
enabled for three minutes after the
button is pressed.
●
Pressing (C) to update data causes [
TRY] to appear on the display and
remain displayed until data updating is
complete.
●
[
FAIL] will appear on the display in
the cases below.
ー
When it has been 30 seconds or
more since the last update and
location information acquisition fails
ー
When it has been 60 seconds or
more since the last update
ー
When data update fails after you
press (C)
●
The display range for the distance to a
destination is 0 to 99,999 meters (0 to
327,995 feet). [
-----] will be shown
for the distance to the destination when
it is outside the display range.
●
[ERR] will appear on the display if
connection fails for some reason.
●
The message [NO-DATA] will appear
when there is no data in Location
Memory.
●
[FAILED]
n
[POSITION] will appear in
sequence if the first location
information acquisition fails.
●
[
] or [G] will flash on the display if the
watch detects abnormal magnetism
while Location Indicator is in use.
●
[ ERR] will appear on the display if a
direction sensor error occurs while
Location Indicator is in use.
Auto Altitude Calibration
Enabling auto altitude calibration with CASIO
WATCHES will cause altitude values to be
acquired by CASIO WATCHES, which will be
used to automatically correct the watch’s
altitude reading.
Important!
●
Use CASIO WATCHES to enable or
disable auto altitude calibration. It
cannot be enabled or disabled on the
watch.
Note
●
If an altitude value acquired by CASIO
WATCHES satisfies accuracy
conditions, the watch will automatically
correct is altitude reading.
●
Auto altitude calibration is performed
at the same time as auto time
adjustment.
●
Auto altitude calibration is not
performed for 12 hours after the time
setting is adjusted manually.
Watch Operation Guide 5713
18
Loading ...
Loading ...
Loading ...