Loading ...
Loading ...
Loading ...
1. Enter the Altimeter Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
This displays the current altitude and
enters the Altitude Offset Mode.
Crown
3. Rotate the crown to calibrate the
displayed value to that of a local altitude
(elevation) marker.
Setting range: -3,000 to 10,000 meters (or
-9,840 to 32,800 feet)
Setting unit: 1 meter (or 5 feet)
●
To return the altitude setting to its initial
factory default, press (A) and (C) at the
same time.
4. Push the crown back in and then lock it.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Checking the Altitude
Differential from a Reference
Point
After you set a reference altitude, the second
hand of the watch will indicate the difference
between your current altitude and the
reference altitude. This makes it easy to
measure the altitude difference between two
points while climbing or trekking.
●
Setting the Altitude Differential
Measurement Range
1. Enter the Altimeter Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
This displays the altitude for your current
location.
Crown
3. Press (B) twice.
This displays the altitude differential
measurement range.
4. Rotate the crown to select either [100m] or
[1000m].
[100m]: ±100 meters (±328 feet) in 5-
meter (16-foot) units
[1000m]: ±1000 meters (±3280 feet) in
50-meter (164-foot) units
5. Push the crown back in and then lock it.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
●
Measuring Altitude
1. Use the contour lines on your map to
determine the altitude differential between
your current location and your destination.
2. Take an altitude reading of your current
location.
l
Checking the Current Altitude
3. Hold down (D) for at least two seconds to
set your current location’s altitude as the
reference altitude.
This displays [DIFF RESET]
n
[RESET]
and then your current altitude.
●
The function hand (Altitude Differential
Indicator) will indicate the difference
between the reference altitude and the
current altitude reading. At this time, the
function hand should indicate ±0 m (±0
feet).
Current location altitude
Altitude differential indicator
Watch Operation Guide 5713
36
Loading ...
Loading ...
Loading ...